Subject	Takes a very strong press to remove/install the bearing
Posted by	Zirvana on August 18, 2005 at 12:31 PM
	This message has been viewed 29 times.
In Reply To	I'm hoping for the best. Nobody in Cortland has the bearing posted by cherry on August 18, 2005 at 11:36 AM
Message	assembly into the steering knuckle. The FSM has you use 3 different drifts to press out/in the seals, axel and bearing assembly from the steering knuckle. The nut that hold on the axle on the steering knuckle needs to be replaced as it has a flange that gets bent over to secure the nut from rotating. The retaining ring can be reused. Good luck....& try to enjoy ZCON!!
Follow Ups	30 miles short - cherry 19:40:40 08/17/05 Could have been worse I suppose. At least your close - Gold Z 19:48:50 08/17/05 Thanks for the words of encouragement. - cherry 11:45:18 08/18/05 Ouch...but atleast you're going/at Zcon :( - SimplyZ(MD) 21:10:01 08/17/05 That sucks...good luck with the repair... - BradZ (FL) 22:44:00 08/17/05 Sorry to hear about that. There's a group of us leaving for - Dave N 00:36:17 08/18/05 Sorry I missed you guys. :-( - cherry 11:43:18 08/18/05 That sucks man. Is your car really cherry red? (n/m) - Payce 10:07:35 08/18/05 No, it's ultra red. I chose my screen name before I had - cherry 11:40:16 08/18/05 About the only thing you can damage that would not be - Zirvana 11:03:21 08/18/05 I'm hoping for the best. Nobody in Cortland has the bearing - cherry 11:36:46 08/18/05 Takes a very strong press to remove/install the bearing - Zirvana 12:31:34 08/18/05 Bummer! Hope to see you tonight then?? (n/m) - Dallas DamonZ 18:23:42 08/18/05
Post a Followup	You cannot reply to this message because you are not logged in.