Subject	The crows foot I had was a cheapie and it kept
Posted by	Shawn300zTT GT28R MD on August 08, 2005 at 1:08 PM
	This message has been viewed 31 times.
In Reply To	that last bolt isn't bad with a 14mm crows foot (n/m) posted by Guapo on August 08, 2005 at 11:18 AM
Message	flexing open on the bolt head. I ended up using a 14mm stubby closed end wrench while sticking a crowbar back there to pry against it to break it loose. NO, This picture is not photoshopped. It took many times to take this picture. Setting up the timer, shutter speed etc, then jumping on my bike and getting the tire to spin. AIM:Shawn300zxTT "I just took 45 min and scrubbed the heck out of my rear" teambushido(San Diego, CA) 19:24:51 12/11/04 1991 Stage _ TT 5spd (Turbo Upgrade in process) 1990 2+2 Na Stage 3 Auto 11 Sec Eagle Talon Tsi AWD, Daily Driver. 2004 Honda CBR 600RR (Candy blue)
Follow Ups	A/C Compressor is locked up....estimate for repair? - atl300zxtt 10:58:14 08/08/05 Buy a working used one, install it yourself. (n/m) - YugoBernie (NoVA) 11:08:36 08/08/05 i would except i know the pain removing that last bolt - atl300zxtt 11:16:27 08/08/05 that last bolt isn't bad with a 14mm crows foot (n/m) - Guapo 11:18:26 08/08/05 agreed (n/m) - aliaZ 11:29:11 08/08/05 that is how i removed it. - atl300zxtt 11:32:05 08/08/05 fwiw, I leave it off when reinstalling. The 3 other - Guapo 11:38:56 08/08/05 2nd. (n/m) - Woody75 (Denver) 11:44:16 08/08/05 The crows foot I had was a cheapie and it kept - Shawn300zTT GT28R MD 13:08:35 08/08/05 yep (n/m) - Spee 17:53:52 08/08/05 apparently i need a receiver dryer as well - atl300zxtt 11:53:31 08/08/05 up front... - Zluster(Hating Socal) 11:55:59 08/08/05 easily removed and installed without removing much? (n/m) - atl300zxtt 12:34:38 08/08/05 Re: easily removed and installed without removing much? - Zluster(Hating Socal) 15:20:30 08/08/05 if you need a good used compressor email me (n/m) - EricTTZ 12:26:31 08/08/05 you've got mail (n/m) - atl300zxtt 12:56:47 08/08/05
Post a Followup	You cannot reply to this message because you are not logged in.