Subject	It's hard to tell from the pic, but the rod is twisted..
Posted by	Good2Zya on August 16, 2000 at 6:18 AM
	This message has been viewed 18 times.
In Reply To	My theory on Kyle's engine broken bottem end... posted by MikeH(Phoenix) on August 16, 2000 at 01:29 AM
Message	What ever cause it to brake did so because it twisted it. I see what you're saying about the girdle though. If the rod brake was a clean one than yes, I would agree that it most likely was the inital failure, but something put a lot of twisting force on it causing it to fail. Fred (TEC Turbo's WORST nightmare) 95 300TT SGP Stage..Who knows..lol Dynoed 539.4 RWHP, 481.2 Lbs. Torque Pump Gas @ 17 Lbs. of Boost NO NOS!!
Follow Ups	My theory on Kyle's engine broken bottem end... - MikeH(Phoenix) 01:29:13 08/16/00 It's hard to tell from the pic, but the rod is twisted.. - Good2Zya 06:18:29 08/16/00
Post a Followup	You cannot reply to this message because you are not logged in.