Subject	well i say..
Posted by	nizmoGTR on July 22, 2005 at 4:21 PM
	This message has been viewed 18 times.
In Reply To	Need some advice... posted by Slottoz on July 22, 2005 at 04:18 PM
Message	i say go with the cheaper one if its fully balenced because if its not it might cause pre-mature bearing wear -my 2 cents
Follow Ups	Need some advice... - Slottoz 16:18:23 07/22/05 Go Fishcer or Unorthodox. The other units have been - Milo (Sport Z Magazine) 16:20:56 07/22/05 The Auto-Specialties pulley has been around for a long time - Z-Jay (Edmonton, AB) 01:34:37 07/23/05 well i say.. - nizmoGTR 16:21:08 07/22/05 some of the cheaper ones dont have the timing mark - scubasteve (rebuilding) 16:35:07 07/22/05 BTW- Stuffs out, have a tracking # for you. (n/m) - Milo (Sport Z Magazine) 16:37:36 07/22/05 Try to get your pulley(s) from a source that sells... - WAGGZ 16:42:00 07/22/05 Re: Try to get your pulley(s) from a source that sells... - Team7 16:51:01 07/22/05 i think SGP has them for $210 - Zski (The Forgotten Z) 17:03:08 07/22/05 2nd (n/m) - Turnerscasa (Dallas) 21:44:36 07/22/05 I am in the same boat, - SoloCon 21:37:22 07/22/05
Post a Followup	You cannot reply to this message because you are not logged in.