Subject	bad news inside:
Posted by	ZEngineer on July 17, 2005 at 3:01 PM
	This message has been viewed 383 times.
In Reply To	Pic request for ppl with stillen sport wings, how do>>> posted by z-line(ATL) on July 17, 2005 at 02:23 PM
Message	When they test-fitted your wing, I bet it looked like this: And if you tried to line up the side of the wing with the side of the hatch, it would either crack or buldge in the center, right? The only thing you can do is to SCREW the wing in place (forget about double sided tape, that won't hold it), a good idea is to put lots of urethane glue in there too. Then, your body shop will have to mold the wing into the proper shape by adding fiberglass to the wing's edge, to make it follow the hatch. If he does it right, it should look like this: Also, contrary to popular belief, if the shop uses quality fiberglass filler and does a good job, it won't crack. Good luck. _________________________________________________________________________________ "The Z is the cause and the solution to all my problems" -- Me
Follow Ups	Pic request for ppl with stillen sport wings, how do>>> - z-line(ATL) 14:23:28 07/17/05 bad news inside: - ZEngineer 15:01:57 07/17/05 where do I put the screws? and isn't that gonna look> - z-line(ATL) 15:12:00 07/17/05 you screw into the wing from inside the hatch (n/m) - PunkZTT(Phoenix) 15:19:26 07/17/05 Vote to FAQ - Good job with the post. (n/m) - BlitZ95TT 16:22:26 07/17/05 Looks like I wasn't the only that happened to... - 619ZTT 19:09:19 07/17/05 which leads me to think that Kaminari had mold issues - ZEngineer 08:04:05 07/18/05 stillen's wing is made out of urethane i believe - Jzx (next-gear.com) 21:19:14 07/17/05 Stilen I have came pre drilled with small counter sunk - kdwest 06:09:28 07/18/05
Post a Followup	You cannot reply to this message because you are not logged in.