TwinTurbo.NET: Nissan 300ZX forum - Re: whouldn't it be wiser to use braces to hold the air guides?
People Seeking Info
 
   


     
Subject Re: whouldn't it be wiser to use braces to hold the air guides?
     
Posted by kuah@splparts.com on July 13, 2005 at 1:05 PM
  This message has been viewed 48 times.
     
In Reply To whouldn't it be wiser to use braces to hold the air guides? posted by CAP927 (Boston) on July 13, 2005 at 12:21 PM
     
Message That was taken into consideration -- this is a 1.25" diameter billet 6061 aluminum rod, even with the drilled hole it is still equivalent in cross section to a 1.2" diameter rod (which is much thicker than the v1 tension rods). Also with the bolts installed there are no voids in the structure, so there is really no compromise in the strength.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.