Subject	Pressurization of block/cylinder with compressor....
Posted by	dilly yo on July 05, 2005 at 11:25 PM
	This message has been viewed 44 times.
Message	Checking for a failing HG and know that you can pressurize each of the cylinders just like in a LD test except not worry about air loss value and just look in the rad for bubbles forming. My question is what pressure should I pressurize too? If my thinking is correct this should be done on a cold engine since heat will expand the AL heads or Fe block and potentially seal any cracks if its happens to be a leak other than the HG, correct? --If my grandmother had a penis she would be my grandfather!!.....6/8/05 My Fiancee' Disclaimer: My fiancee' is Romanian and she always does this interprutation from her native language to english. Shit sounds soooo stupid!
Follow Ups	Pressurization of block/cylinder with compressor.... - dilly yo 23:25:48 07/05/05 1000 PSI. Also you need something to keep the - AzHeat 00:20:00 07/06/05 LOL! 1000 psi...sorry my compressor can't do that! - dilly yo 00:44:47 07/06/05 What do you think the pressure of combustion is? - AzHeat 02:36:40 07/06/05 you do it the other way around.... - Red October 01:22:12 07/06/05 Actually you can't do it either way. Sometimes the - dilly yo 10:50:08 07/06/05 2nd, you can do it either way, ive seen it done before - Borg79(ON) 11:01:21 07/06/05
Post a Followup	You cannot reply to this message because you are not logged in.