Subject	Re: 2nd MAF voltage...
Posted by	SpecNATT (Houston) on June 28, 2005 at 2:14 AM
	This message has been viewed 64 times.
In Reply To	2nd MAF voltage... posted by shawn300zTT GT28R soon on June 27, 2005 at 07:34 PM
Message	"Key On Engine Off, go to Sensor check mode on the SAFC2. Check the voltage values. If your voltage is reading 5ish volts then you have an open in your ground. If your have a voltage of ALMOST 0Vs, then you have an open in the Signal wire, OR your MAF unit it's self is not receiving power. You should be getting a reading of .400-.550Voltes" TT dynoed 340 rwhp 361rwtq before rebuild w/ SGP block/ GMS550BBs La-Z-Link.
Follow Ups	2nd MAF voltage... - shawn300zTT GT28R soon 19:34:21 06/27/05 There will be a difference between both MAFS - Carlos Ramirez 19:37:06 06/27/05 mine both get roughly .4V with motor not running - Guapo 19:40:21 06/27/05 Did you buy your second maf from Z1? - Wilks 20:27:40 06/27/05 between yourself? - Marshall 21:21:53 06/27/05 Re: between yourself? - Wilks 22:26:16 06/27/05 Re: 2nd MAF voltage... - SpecNATT (Houston) 02:14:42 06/28/05
Post a Followup	You cannot reply to this message because you are not logged in.