TwinTurbo.NET: Nissan 300ZX forum - For my 94TT..my wife moved the crank bolt slowly so I
People Seeking Info
 
   


     
Subject For my 94TT..my wife moved the crank bolt slowly so I
     
Posted by Zirvana on June 08, 2005 at 4:46 PM
  This message has been viewed 82 times.
     
In Reply To i had a tranny issue as well posted by SuparexTT on June 08, 2005 at 04:27 PM
     
Message could see if the splines were lined up & moving the input shaft; my son was working the back end trying to push the tranny forward on a hydrolic jack; and I was under the tranny pushing/pulling/aligning, etc. Went in OK. I did install some of the tranny bolts (on the steel metal bracket places) to help pull it together (but I made sure that it was going in without much force).

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.