TwinTurbo.NET: Nissan 300ZX forum - yes the cup-like metal housing for the subframers stays
People Seeking Info
 
   


     
Subject yes the cup-like metal housing for the subframers stays
     
Posted by Zrevolver on June 06, 2005 at 10:46 AM
  This message has been viewed 33 times.
     
In Reply To The outermost shell stays in for the ES bushings, right? posted by Joe(NoVA) on June 06, 2005 at 09:25 AM
     
Message it is a royal PAIN in the ass to get the bushing out of it. I didnt try the burn-out technique, heard it is successful.

Instead I perforated the bottom of the "cup" with an air hammer and peeled it back like flower petals so that the stupid press could press them out, then hammered the bottom of the "cup" back in place to hold the bushings in.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.