| Part of the clutch change instructions: 9. Remove the clutch slave cylinder (2 x 14 mm), loop it back around to
hang on the front suspension on its rubber line to get it out of the way. 10. Remove the power lead to the back of the starter (1 x 12 mm nut).
Disconnect the thin starter relay wire, it's in front of the starter. Remove
the wiring bracket on the side of the engine to get the starter off (1 x 10
mm). The back half is under the starter's bolt. If the passenger precat is
removed, skip this next part. Unbolt the heat shield 'window' (2 x 10
mm). This allows enough space to get the starter around the precat if it's
still installed. Remove the starter (2 x 14 mm, 1 nut and 1 bolt) and
wiring bracket.
|
