Subject	Things like this cause people to go ted bundy..nzr
Posted by	Tissan© on May 28, 2005 at 9:10 PM
	This message has been viewed 414 times.
Message	So i go to time my engine, get to the point where i had to put the top chain tensioner on. Go to torque the first bolt, start tighting but it feels weird like its just turning and not getting tight. So i take it off look at both of the threads and everything seems fine. So i do it agian, get a few turns (only 20 NM of torque, i was being a dumbass :( So then i feel the dreaded little snap, shit. I knew this was going to happen. alright, so i'm thinking about this. I have a few options. Drill it out, heli-coil Drill it out, re-thread Go buy a small extractor and use that to remove broken bolt What does everyone think i should do about this? I'm just wondering, never had a bolt break off in my head before. if the mods could just leave it up for a little while, that would be nice :) ______________________________________________ "If it doesn't make it go fast or stop fast, then forget it"-Jesse James "Someone just needs to blow up z1 and make the world a better place"-unknown
Follow Ups	Things like this cause people to go ted bundy..nzr - Tissan© 21:10:50 05/28/05 Well personally I wouldn't use a 'bolt extractor' - JokerF15 (NyxMotorsports) 21:17:43 05/28/05 Re: Things like this cause people to go ted bundy..nzr - RMiller 21:25:19 05/28/05 2nd - TTZMatt 21:42:33 05/28/05 3rded. Get a good set and use the right size and use - Ghozt 21:45:47 05/28/05 Weld a rod on it, then weld a nut on the rod. - zboost 22:10:07 05/28/05 If its just broke and not stuck in there(crossthreaded) - Spddracer 06:06:44 05/29/05 unfortunately, I have no idea : ) (n/m) - 2eZee 16:16:32 05/29/05
Post a Followup	You cannot reply to this message because you are not logged in.