I've e-mailed both Ash and Greg D about thier recommendations about using a WB02 and the setup's that they use.
Ash has personal experience with the PLX devices and highly recommend's them.
Greg D said he likes the Motec setups and is what he uses in his shop. I really couldn't find very much info about these and they are very expensive!
There is a couple of people here that have a Zeltronics WB02 setup and they like thier setup.What was told to me both Ash and Greg in concerns about having a dual sensor system is that its overkill. When you do your first runs and get your base #'s you will want to switch DP's a few times to make sure your #'s correlate. Most Dyno's with A/F monitering only use 1 sensor. Also when/if a fuel problem arrises it will affect both banks equally so no matter which side you a monitering you will see the problem arrise. Since you have the Zemulator you will not need to have a device to datalog any of the reading becuase you can "piggyback" the WB02 into the Zem and datalog everything. Replay and make changes as needed. I recently purchased the Zem (arriving today thanks Ash!!!!) and will probably be going with a PLX device. I need to do some more research about the right unit so I can leave it constantly reading and not have any issues with the 5v narrowband 02 reading not correlating with the ECU. The FJO is a very nice setup and was one I was debating going with becuase it does have the dual sensor monitering ability but as stated above will be overkill along with extra $$$ that could be spent elsewhere. Hope that helps you out. CowBoy
 |
