Subject	They usually charge $75 for 3 pulls w/ a/f
Posted by	Greg (MA) on May 16, 2005 at 7:19 PM
	This message has been viewed 35 times.
In Reply To	side note posted by Rickytl (MA) on May 16, 2005 at 06:48 PM
Message	But since I was there on a "Club day" (went with a few friends who have SRT's), it was $60 for 3-5 pulls and a/f. There's going to be a ZCCNE Dyno day soon (June 4th?) that might be like, $50-60ish, on a dynapack (direct axle to hub) instead of a dynajet (in ground rollers). I can get you more information on that if you want.
Follow Ups	Have fun with THESE dyno charts! - Greg (MA) 15:58:19 05/16/05 To avoid issues like that...... - BOOZTD 3 16:10:00 05/16/05 That shouldn't make it "look" lean since we must assume the - Scotts94z32 16:12:17 05/16/05 Unsure of the timing at this moment... - Greg (MA) 16:42:05 05/16/05 Go to your local auto store and buy a timing gun. You can - Scotts94z32 16:47:13 05/16/05 Whoa! That's really lean! I am sure that the leak in - Ash's Z 16:41:43 05/16/05 I've been reading through the 6P's - Greg (MA) 16:46:49 05/16/05 The 7th "P". Good "point". Did you see how smooth is AFR - Scotts94z32 16:49:28 05/16/05 The pulsations of the exhaust create hi/low pressure waves - Ash's Z 17:46:52 05/16/05 I'm going to try and explain a few things here.. > - Ash's Z 23:28:29 05/16/05 Boost leak check, check timing, and get back to us - JokerF15 (NyxMotorsports) 16:50:57 05/16/05 How much boost do you get, with the boost jets removed?? (n/m) - SactoTodd 16:57:40 05/16/05 peak is about 11psi (n/m) - Greg (MA) 17:37:27 05/16/05 Lil bit a duck (that's right) tape will fix that right up. (n/m) - Kenny 17:06:09 05/16/05 side note - Rickytl (MA) 18:48:09 05/16/05 They usually charge $75 for 3 pulls w/ a/f - Greg (MA) 19:19:56 05/16/05 N.E. Dyno in Woostah is where we've gone the last 2 years. - Dave N 20:43:49 05/16/05 NE Dyno is under new ownership... - Greg (MA) 21:06:58 05/16/05 A boost controller might be better than boost jets - s3trios 19:52:53 05/16/05 greddy should warranty that .... - tyler@boostpro.net 21:52:17 05/16/05
Post a Followup	You cannot reply to this message because you are not logged in.