TwinTurbo.NET: Nissan 300ZX forum - Unsure of the timing at this moment...
Subject
Unsure of the timing at this moment...
Posted by
Greg (MA)
on May 16, 2005 at 4:42 PM
This message has been viewed
34
times.
In Reply To
That shouldn't make it "look" lean since we must assume the
posted by Scotts94z32
on May 16, 2005 at 04:12 PM
Message
I dont have access to a timing gun so I'll have to ask the previous owner
what it was being that he had it retimed prior to me purchasing the car.
Follow Ups
Have fun with THESE dyno charts!
-
Greg (MA)
15:58:19 05/16/05
To avoid issues like that......
-
BOOZTD 3
16:10:00 05/16/05
That shouldn't make it "look" lean since we must assume the
-
Scotts94z32
16:12:17 05/16/05
Unsure of the timing at this moment... -
Greg (MA)
16:42:05 05/16/05
Go to your local auto store and buy a timing gun. You can
-
Scotts94z32
16:47:13 05/16/05
Whoa! That's really lean! I am sure that the leak in
-
Ash's Z
16:41:43 05/16/05
I've been reading through the 6P's
-
Greg (MA)
16:46:49 05/16/05
The 7th "P". Good "point". Did you see how smooth is AFR
-
Scotts94z32
16:49:28 05/16/05
The pulsations of the exhaust create hi/low pressure waves
-
Ash's Z
17:46:52 05/16/05
I'm going to try and explain a few things here.. >
-
Ash's Z
23:28:29 05/16/05
Boost leak check, check timing, and get back to us
-
JokerF15 (NyxMotorsports)
16:50:57 05/16/05
How much boost do you get, with the boost jets removed?? (n/m)
-
SactoTodd
16:57:40 05/16/05
peak is about 11psi (n/m)
-
Greg (MA)
17:37:27 05/16/05
Lil bit a duck (that's right) tape will fix that right up. (n/m)
-
Kenny
17:06:09 05/16/05
side note
-
Rickytl (MA)
18:48:09 05/16/05
They usually charge $75 for 3 pulls w/ a/f
-
Greg (MA)
19:19:56 05/16/05
N.E. Dyno in Woostah is where we've gone the last 2 years.
-
Dave N
20:43:49 05/16/05
NE Dyno is under new ownership...
-
Greg (MA)
21:06:58 05/16/05
A boost controller might be better than boost jets
-
s3trios
19:52:53 05/16/05
greddy should warranty that ....
-
tyler@boostpro.net
21:52:17 05/16/05
Post a
Followup
You cannot reply to this message because you are not
logged in
.