Subject	so you toasted the motor too? fingered it would
Posted by	genic on May 16, 2005 at 2:10 PM
	This message has been viewed 32 times.
In Reply To	When good bearings go bad posted by DAYTONAZ on May 16, 2005 at 02:04 PM
Message	..thats a nice failure you have there. i would feel that i accomplished something if i did that. :)
Follow Ups	When good bearings go bad - DAYTONAZ 14:04:07 05/16/05 so you toasted the motor too? fingered it would - genic 14:10:16 05/16/05 LOL.... agree...that is some major kill right dur. (n/m) - Milo (Sport Z Magazine) 14:36:08 05/16/05 Not sure if I even bent one valve to be honest - DAYTONAZ 14:42:03 05/16/05 That makes no sense you realize? (n/m) - YugoBernie (NoVA) 15:07:21 05/16/05 How so? knowing the unforgiving nature of timing belt - DAYTONAZ 15:17:05 05/16/05 Just try replacing the tensioners and pulley ect... (n/m) - CrazyGreek 18:03:34 05/16/05 It would take about 30min to reinstall pullies & belt. (n/m) - YugoBernie (NoVA) 08:18:19 05/17/05 damn that sucks dude....but I do like your attitude - myzislow 14:10:52 05/16/05 Should replace the tensioners, reset T. belt & give it a try (n/m) - YugoBernie (NoVA) 14:38:37 05/16/05 Also - IMHO all 3 idlers didn't fail @ one time, I get the - YugoBernie (NoVA) 14:42:56 05/16/05 Interesting that all three are bad and fail at once. (n/m) - nowayout 14:46:56 05/16/05 Well let me give you the prelude to the story - DAYTONAZ 15:08:36 05/16/05 I did the same thing..but luckily only my cam seals gave out (n/m) - Pushin'twins 14:57:40 05/16/05 OUCH! If I could make a suggestion, pull the bottom end - Ash's Z 16:22:16 05/16/05 Hey Ash, I figured I may pull the bottom end apart - DAYTONAZ 16:34:02 05/16/05 Ouch. It's posts like these that convince me never to - olyar15 16:47:19 05/16/05 Sorry to hear that. My turn is coming, probably July. (n/m) - MOTRSPRT--ID 17:25:45 05/16/05 Do you have any rubbing problems with these ADR wheels?? - 300zx_lee 18:15:21 05/16/05
Post a Followup	You cannot reply to this message because you are not logged in.