TwinTurbo.NET: Nissan 300ZX forum - Inconel Install question... help!!!
People Seeking Info
 
   


     
Subject Inconel Install question... help!!!
     
Posted by Joe(NoVA) on May 07, 2005 at 6:48 PM
  This message has been viewed 58 times.
     
In Reply To HKS 2530/ Inconel Dyno: Special Thanks to Seb +Greg posted by trueyungasian on May 07, 2005 at 04:48 PM
     
Message On the rear uppermost stud that you have to cut for the manifolds to fit... did you use one of the thick factory washers? I can't seem to get it to fit... should I just use the nut? Thinner washer? thoughts? how did you do it?

(i'm out in the garage right now doing this)

Joe
Engine Rebuild in Progress: Sport 530bb's + Inconel :-)
AIM: hoyatiger81

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.