Subject	Depends upon tune/build and how the car will be used
Posted by	SeedyROM on May 04, 2005 at 11:43 AM
	This message has been viewed 23 times.
In Reply To	isn't max Hp at around 6500 or so? (n/m) posted by Rickytl (MA) on May 04, 2005 at 08:48 AM
Message	But on a stock turbo car, it is around that area. For example, I think Seb with his Sport 700s has an 8000rpm limit with his built motor so that he can be in the power range longer (as those turbos take some time to spool and get going). If you think defending quality shops and site sponsors with proven records makes him a whore, then you are the ones with the problem. Stop being bitches. - October 21, 2003 at 06:16 PM My Zs: www.zheaven.com - DOWN - Have a question about either of my 300ZXs? Answers lie within. Member: www.SoCalZCrew.com - Come find out how we do it in the West!
Follow Ups	CHIPPED ECUS: What RPM is your rev limiter set at? - ConVerTT 08:40:21 05/04/05 isn't max Hp at around 6500 or so? (n/m) - Rickytl (MA) 08:48:02 05/04/05 Depends upon tune/build and how the car will be used - SeedyROM 11:43:21 05/04/05 The standard JWT ECU red lines at 7200... But many tell - BlitZ95TT 08:49:13 05/04/05 7900 (n/m) - hey GotBo0st 08:52:03 05/04/05 the guages lie to you. it says 7400. but they are "off" (n/m) - Halo Z 09:03:49 05/04/05 Usually by 200 rpms. Dash is 200 rpms higher. (n/m) - Arnel@Z32racing.com 10:06:39 05/04/05 Mine is set at 8400 but........... - SpdRacr 09:51:12 05/04/05 Have you taken it over 8000RPM under high load? - maglito 10:15:26 05/04/05 If I remeber...... - SpdRacr 11:19:30 05/04/05 New MS solid lifter cams...hmm - maglito 11:36:44 05/04/05 7200 is the stock setting. (n/m) - ENVYMYZ 13:46:43 05/04/05 JWT ECU is 7200. Stock is not. (n/m) - Only1Z 15:29:25 05/04/05 Mine cuts out at 7200. Ecu is stock. *shrug* (n/m) - ENVYMYZ 15:41:01 05/04/05 Re: Mine cuts out at 7200. Ecu is stock. *shrug* - Halo Z 16:41:30 05/04/05 Good point. Although this was also verified via aftermarket - ENVYMYZ 16:56:45 05/04/05
Post a Followup	You cannot reply to this message because you are not logged in.