Subject	New MS solid lifter cams...hmm
Posted by	maglito on May 04, 2005 at 11:36 AM
	This message has been viewed 33 times.
In Reply To	If I remeber...... posted by SpdRacr on May 04, 2005 at 11:19 AM
Message	Thanks for the info.
Follow Ups	CHIPPED ECUS: What RPM is your rev limiter set at? - ConVerTT 08:40:21 05/04/05 isn't max Hp at around 6500 or so? (n/m) - Rickytl (MA) 08:48:02 05/04/05 Depends upon tune/build and how the car will be used - SeedyROM 11:43:21 05/04/05 The standard JWT ECU red lines at 7200... But many tell - BlitZ95TT 08:49:13 05/04/05 7900 (n/m) - hey GotBo0st 08:52:03 05/04/05 the guages lie to you. it says 7400. but they are "off" (n/m) - Halo Z 09:03:49 05/04/05 Usually by 200 rpms. Dash is 200 rpms higher. (n/m) - Arnel@Z32racing.com 10:06:39 05/04/05 Mine is set at 8400 but........... - SpdRacr 09:51:12 05/04/05 Have you taken it over 8000RPM under high load? - maglito 10:15:26 05/04/05 If I remeber...... - SpdRacr 11:19:30 05/04/05 New MS solid lifter cams...hmm - maglito 11:36:44 05/04/05 7200 is the stock setting. (n/m) - ENVYMYZ 13:46:43 05/04/05 JWT ECU is 7200. Stock is not. (n/m) - Only1Z 15:29:25 05/04/05 Mine cuts out at 7200. Ecu is stock. *shrug* (n/m) - ENVYMYZ 15:41:01 05/04/05 Re: Mine cuts out at 7200. Ecu is stock. *shrug* - Halo Z 16:41:30 05/04/05 Good point. Although this was also verified via aftermarket - ENVYMYZ 16:56:45 05/04/05
Post a Followup	You cannot reply to this message because you are not logged in.