Subject	Have you taken it over 8000RPM under high load?
Posted by	maglito on May 04, 2005 at 10:15 AM
	This message has been viewed 80 times.
In Reply To	Mine is set at 8400 but........... posted by SpdRacr on May 04, 2005 at 09:51 AM
Message	Where is your tach (RPM) @ 200mph? Were you using Yokohama AVS intermediate tires 255 40/17 during your high speed run? (that size should have 25" diameter but luke could confirm the exact diameter for that make model and size tire) (stock size in rear is 24.7in) . I am trying to decide where to set my rev limiter on my car and plan to be quite a bit more conservative than you. 8k RPM would probably be the upper limit with 7.7-7.8k being more likely. My understanding is: to be safe exceeding 8k rpm with our motor requires using solid lifters.
Follow Ups	CHIPPED ECUS: What RPM is your rev limiter set at? - ConVerTT 08:40:21 05/04/05 isn't max Hp at around 6500 or so? (n/m) - Rickytl (MA) 08:48:02 05/04/05 Depends upon tune/build and how the car will be used - SeedyROM 11:43:21 05/04/05 The standard JWT ECU red lines at 7200... But many tell - BlitZ95TT 08:49:13 05/04/05 7900 (n/m) - hey GotBo0st 08:52:03 05/04/05 the guages lie to you. it says 7400. but they are "off" (n/m) - Halo Z 09:03:49 05/04/05 Usually by 200 rpms. Dash is 200 rpms higher. (n/m) - Arnel@Z32racing.com 10:06:39 05/04/05 Mine is set at 8400 but........... - SpdRacr 09:51:12 05/04/05 Have you taken it over 8000RPM under high load? - maglito 10:15:26 05/04/05 If I remeber...... - SpdRacr 11:19:30 05/04/05 New MS solid lifter cams...hmm - maglito 11:36:44 05/04/05 7200 is the stock setting. (n/m) - ENVYMYZ 13:46:43 05/04/05 JWT ECU is 7200. Stock is not. (n/m) - Only1Z 15:29:25 05/04/05 Mine cuts out at 7200. Ecu is stock. *shrug* (n/m) - ENVYMYZ 15:41:01 05/04/05 Re: Mine cuts out at 7200. Ecu is stock. *shrug* - Halo Z 16:41:30 05/04/05 Good point. Although this was also verified via aftermarket - ENVYMYZ 16:56:45 05/04/05
Post a Followup	You cannot reply to this message because you are not logged in.