TwinTurbo.NET: Nissan 300ZX forum - i would assume you are aware of the top bleeder...
People Seeking Info
 
   


     
Subject i would assume you are aware of the top bleeder...
     
Posted by Borg79(ON) on May 02, 2005 at 6:28 PM
  This message has been viewed 26 times.
     
In Reply To the clutch problem is small posted by mousersix (San Antonio) on May 02, 2005 at 05:31 PM
     
Message but it sounds like a problem with the master cyl. seals are going, but you should loose fluid if that was it...He has no booster as he is an NA


-"Chains baby, chains.......Z will grip like a champ. (n/m) - Wolf [Pittsburgh] 14:56:58 05/10/00"
How to Check Turbos: "1st remove exhaust and pre-cats. Then fire that mother up, rev it to at least 5000 rpm and then stick your finger into the hole on the back of the turbo. If the turbine grinds your finger down, then your turbo is working. If your finger gets ground off farther than the second knuckle, then your turbos are good for at least another 60k miles! Don't forget to check both sides." -I am Z-ing Double
-"The world's two biggest mysteries: The meaning of life and fitting the Howe radiator into the Z..." -Seedyrom, circa 2000

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.