| Message |
[ http://www.twinturbo.net/net/viewmsg.aspx?forum=technical&msg_id=936776 ] According to JWT you are supposed to tap the 3/8" to 5/8" pipe threaded elbow into the bottom of the factory recirc valve on the passenger side( 3/8 side is the side you tap into the piping). The recirc valve is mounted on the upper intercooler piping(to the throttle bodies). Being that you do not have the factory recircs you need to find an area with the same pressure zone. Being that the factory recirc is mounted on the upper intercooler piping, I would tap and thread it into there, it will work just fine. Just make sure you tap the elbow in a spot that allows you enough room to run the hose up to the drivers side idle hose with out any kinks and sharp bends. Also, use a little teflon tape on the threads to ensure a good seal. Hope that helps
 |
 |
