Subject	"yes anyone compared to ash is a newbie"
Posted by	zboost on April 22, 2005 at 8:53 PM
	This message has been viewed 305 times.
In Reply To	update on ecu from ash posted by cossiemodo2000 on April 22, 2005 at 08:43 PM
Message	You sure about that? :) [ http://twinturbo.net/net/viewmsg.aspx?forum=technical&msg_id=404580&words=ash ] "yo yo. writing this one in jail - tight300zx" I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04 we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04 "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)
Follow Ups	update on ecu from ash - cossiemodo2000 20:43:24 04/22/05 "yes anyone compared to ash is a newbie" - zboost 20:53:07 04/22/05 Impressive find zboost! - TPZ93 21:02:32 04/22/05 LOL (n/m) - Tissan© 21:09:05 04/22/05 My 1st post. :) - Ash's Z 21:15:33 04/22/05 You had to start somewhere! - TPZ93 21:29:16 04/22/05 Mine wasn't much better. I asked about auto -> 5-speed - U ZCREAM 21:30:44 04/22/05 I hated looking at your old posts too :-P (n/m) - boileralum 21:37:40 04/22/05 One of my first was "where's the plenum" LOL - I just put my - BummedOutMonkey 21:35:38 04/22/05 still better than my first post... - Longhorn20 00:22:38 04/23/05 I'm going to look at Ash in a whole new perspective now - rufflez 21:39:31 04/22/05 After I look at your sig for more than 15 seconds I want to - DVDBURN (MD) 22:05:01 04/22/05 lol, bookmarked (n/m) - robo (sebring1970) 23:12:41 04/22/05 Wow... even I knew that. (n/m) - Blu Z 23:42:52 04/22/05 Well, thanks for the follow-up to the problem. I hope you - Ash's Z 21:36:32 04/22/05 so what was the fix? - Greg (MA) 23:14:53 04/22/05 Hmm. That was back when I was at Z1 and I didn't have - Ash's Z 01:00:10 04/23/05 That might make sense as I didnt get boost jets with the ECU - Greg (MA) 15:15:08 04/23/05
Post a Followup	You cannot reply to this message because you are not logged in.