Subject	here's a thought
Posted by	ZEngineer (TT) on April 22, 2005 at 1:21 PM
	This message has been viewed 184 times.
In Reply To	Kinda disheartening........ posted by BOOZTD 3 on April 22, 2005 at 01:01 PM
Message	The last time I did a compression test, I got about the same reading you mentioned, no cylinder above 120psi for the whole driver's side bank. Needless to say, I got in the foetal position in the corner and started shaking uncontrollably. I'm proud to say that I didn't cry though... =) After calming down a bit (thanks to a brisk slap upside the head by Zeus), I went back and did the compression test again, but this time, more careful about how I screwed in my el-cheapo tester. At that point, I got 155psi all across the board. Yaayyy! All this rant to say that if you're using a pretty cheap compression tester, make sure it's screwed in properly. Same applies to your leakdown test since I'm assuming you were using the same (but modified) equipment. Good luck George _________________________________________________________________________________ "The Z is the cause and the solution to all my problems" -- Me
Follow Ups	Kinda disheartening........ - BOOZTD 3 13:01:52 04/22/05 here's a thought - ZEngineer (TT) 13:21:27 04/22/05 Are you always this dramatic .. - PLEAZURE in CA (SD) 13:26:32 04/22/05 Only when it comes to my Z ;) - ZEngineer (TT) 13:28:43 04/22/05 ... (n/m) - spicyZ 13:45:38 04/22/05 2nd (n/m) - Zeus 14:01:50 04/22/05 Rat-bastards. The both of you. - ZEngineer (TT) 14:45:36 04/22/05 I've got what I would call a cheap compression tester and - 240Z FeO2 15:15:24 04/22/05 thats what the rubber o-rings are for (n/m) - BOOZTD 3 15:16:24 04/22/05 So once you've got the hose threaded into the plug hole, - 240Z FeO2 15:34:51 04/22/05 There's no trick to it.. it's just a simple trick - spicyZ 15:38:36 04/22/05 XLNT. Thanks spicy and BOOZTD (n/m) - 240Z FeO2 15:41:49 04/22/05
Post a Followup	You cannot reply to this message because you are not logged in.