Subject	Thanks, all I needed to know. =)
Posted by	whitepearlz on April 21, 2005 at 9:13 PM
	This message has been viewed 108 times.
In Reply To	The best way to answer your question is to say ...... posted by Greg D. (Specialty-Z) on April 21, 2005 at 09:08 PM
Message	On a side note, I know you were having a few issues with the grinding of the welds on the earlier design. I've had these sitting here for quite some time now, waiting to go on. Just curious if you think they should be fine as is, or if I should have them reinforced with some tack welds or something. "funny how I like the a spec fascia more and more now that I have the j spec" - CLOWNSHUE on April 04, 2005 at 2:42 PM WINTER (Also known as a "WISCONSIN WINTER") This is one of Wisconsin's two seasons which lasts approximately 9 months. The other season is the ROAD CONSTRUCTION season, lasting roughly 3 months.
Follow Ups	Wrapping DP's. Good, bad? > - whitepearlz 20:16:06 04/21/05 Good question. I would like to add to that - Spddracer 20:20:50 04/21/05 Wrapping has no effect on noise/resonance. (n/m) - Dave N 20:38:41 04/21/05 Correct....The resonance comes from the free flow of ..... - Greg D. (Specialty-Z) 20:52:08 04/21/05 Also from type of steel you use.....and thickness (n/m) - sweet z (UTAH) 00:55:57 04/22/05 get them Jet Hot coated (n/m) - Spee 20:34:03 04/21/05 2nd'd. (n/m) - Dave N 20:37:42 04/21/05 hey dave did u get my E-mail? (n/m) - Rickytl (MA) 20:48:23 04/21/05 Yep, I'm replying to it.... (n/m) - Dave N 20:52:24 04/21/05 ::shivers^spine:: - Rickytl (MA) 20:55:00 04/21/05 Jethot vs Ceramic coating? - JokerF15 (NyxMotorsports) 00:39:04 04/22/05 nm just got a good link on it... (n/m) - JokerF15 (NyxMotorsports) 00:40:28 04/22/05 I would think moisture would evaporate on dp's - 300zxer 20:37:40 04/21/05 some peeps feel condensation can form during the cool - robo (sebring1970) 21:59:11 04/21/05 Re: Wrapping DP's. Good, bad? > - Greg D. (Specialty-Z) 20:50:45 04/21/05 So is it the same impact with ceramic coating? (n/m) - Dave N 20:53:56 04/21/05 Correct, It would retain more heat and have less temp - Greg D. (Specialty-Z) 20:55:59 04/21/05 what about adding heat sheilds? - Rickytl (MA) 21:02:43 04/21/05 *smack* (n/m) - Dave N 21:05:32 04/21/05 It would depend where the heat shield was placed.... - Greg D. (Specialty-Z) 21:06:44 04/21/05 Interesting...I wonder if there is a tangible difference. - Dave N 21:11:56 04/21/05 Re: Interesting...I wonder if there is a tangible difference. - Rickytl (MA) 21:14:04 04/21/05 Re: Interesting...I wonder if there is a tangible difference. - Greg D. (Specialty-Z) 21:48:01 04/21/05 So, would you say leaving them un-wrapped outweighs - whitepearlz 20:59:23 04/21/05 The best way to answer your question is to say ...... - Greg D. (Specialty-Z) 21:08:26 04/21/05 Thanks, all I needed to know. =) - whitepearlz 21:13:20 04/21/05 If they were mine i would put tacks around the flange - Tissan© 21:23:37 04/21/05 Re: Thanks, all I needed to know. =) - Greg D. (Specialty-Z) 21:41:13 04/21/05 Thanks Greg, I think I will take you up on that. =) - whitepearlz 21:51:12 04/21/05 Any issues with the SS splits version from ~10/03? (n/m) - USCZ 17:27:06 04/22/05 I won't be wrapping mine either. (n/m) - ZFreak (Dallas) 22:34:23 04/21/05 im wrapping mine for temp control only. - genic 23:09:41 04/21/05 Re: im wrapping mine for temp control only. - Greg D. (Specialty-Z) 23:24:22 04/21/05 FYI.....The pipes really do not get too hot without cats. (n/m) - Greg D. (Specialty-Z) 23:28:36 04/21/05 what about shields or wrap on the intake piping - genic 23:12:00 04/21/05 Re: what about shields or wrap on the intake piping - Greg D. (Specialty-Z) 23:26:52 04/21/05 i did that...and what i found after i took it off.. - genic 08:52:40 04/22/05 I agree to a point. (n/m) - sweet z (UTAH) 01:00:15 04/22/05 I agree to a point - sweet z (UTAH) 01:03:31 04/22/05 I want to see the proof of reduced underhood temps. - robo (sebring1970) 21:14:54 04/21/05 I coated mine for the warranty and I figured - Fuzznutz 22:57:57 04/21/05 we need to tape a thermometer to the bottom of someone's - robo (sebring1970) 23:15:41 04/21/05 Heh, maybe so... - Fuzznutz 23:20:06 04/21/05 I have them wrapped on my Z's Dp and mids. As for - Spongerider :) 23:01:54 04/21/05
Post a Followup	You cannot reply to this message because you are not logged in.