Subject	Removing coolant passage casting flash, what is the
Posted by	AzHeat on April 20, 2005 at 12:32 PM
	This message has been viewed 75 times.
Message	best type of cutting bit to use on a drill or air die grinder?
Follow Ups	Removing coolant passage casting flash, what is the - AzHeat 12:32:12 04/20/05 carbide (n/m) - scubasteve (Tampa, FL) 13:25:40 04/20/05 there's a nice little write up in the VFAQ (n/m) - Zeus 14:16:37 04/20/05 Get a carbide burr. look @ what mcmaster has - JokerF15 (NyxMotorsports) 14:32:35 04/20/05
Post a Followup	You cannot reply to this message because you are not logged in.