TwinTurbo.NET: Nissan 300ZX forum - I would say no, you need at least 45mm in the rear with 9.5"
People Seeking Info
 
   


     
Subject I would say no, you need at least 45mm in the rear with 9.5"
     
Posted by Borg79(ON) on April 12, 2005 at 8:47 PM
  This message has been viewed 36 times.
     
In Reply To Will these wheels fit?? posted by MJzTTZ on April 12, 2005 at 02:29 PM
     
Message I just installed some kazera 18x9.5 45mm offset and its fine inside but i get a bit of rubbing on the outside fender...45 is just about perfect (as good as its going to get)


-"Chains baby, chains.......Z will grip like a champ. (n/m) - Wolf [Pittsburgh] 14:56:58 05/10/00"
How to Check Turbos: "1st remove exhaust and pre-cats. Then fire that mother up, rev it to at least 5000 rpm and then stick your finger into the hole on the back of the turbo. If the turbine grinds your finger down, then your turbo is working. If your finger gets ground off farther than the second knuckle, then your turbos are good for at least another 60k miles! Don't forget to check both sides." -I am Z-ing Double
-"The world's two biggest mysteries: The meaning of life and fitting the Howe radiator into the Z..." -Seedyrom, circa 2000

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.