Subject	You measure because high resistance= bad ground= noise and
Posted by	twinturbineZ on March 29, 2005 at 12:13 PM
	This message has been viewed 28 times.
In Reply To	Have car stereo (amplifier) question... posted by Zman987 on March 29, 2005 at 11:24 AM
Message	poor amplifier performance. Use the 200ohm setting measure from battery stud ground to ground point on firewall or grounding point, should be like .001 or lower. Lower is better, then measure from wire end going into amp to ground point or bolt and also from amplifier grounding bolt to battery stud should be the same or slightly higher, again lower is better. So I'm having this dream! I'm in a Turbo Z and these guys are after me, but they can't catch me, So they get a car, but they can't catch me. So they get a plane, and just as their about to catch me, the TWIN TURBOS KICK IN!
Follow Ups	Have car stereo (amplifier) question... - Zman987 11:24:21 03/29/05 why would anybody want to measure the resistance of a - E=mz² 11:34:07 03/29/05 You measure because high resistance= bad ground= noise and - twinturbineZ 12:13:07 03/29/05
Post a Followup	You cannot reply to this message because you are not logged in.