Subject	I have the "new" design and still get some slap (n/m)
Posted by	BOOZTD 3 on March 26, 2005 at 3:42 AM
	This message has been viewed 21 times.
In Reply To	Too much taper and too much pin offset on the original posted by Ash's Z on March 26, 2005 at 12:11 AM
Message
Follow Ups	my Z runs again! Wiseco pistons get a thumbs up. - schuss 14:59:41 03/25/05 sweet, i'll be building my car this winter...also a fellow - DragonSi 15:07:27 03/25/05 it's a good thing they're so awfully pretty, huh? - schuss 15:09:09 03/25/05 congrats man (n/m) - Zeus 15:20:17 03/25/05 Congrats... I'm still tearing my hair out - Joe(NoVA) 15:24:55 03/25/05 When it's done... - BradZ (FL) 15:26:32 03/25/05 5 months downtime in 18 months ownership - schuss 15:31:27 03/25/05 3 years ownership, about 6 months total drive time for me:( (n/m) - BOOZTD 3 03:51:59 03/26/05 =) (n/m) - Ash's Z 15:25:53 03/25/05 The Wisecos that I have heard make noise didn't start until - boileralum 15:26:32 03/25/05 gimme a couple days and i'll let you know. ;) (n/m) - schuss 15:34:45 03/25/05 Same - BOOZTD 3 16:00:41 03/25/05 Re: Yep - same RPM range for mine and nissanzxman's (n/m) - boileralum 22:20:44 03/25/05 agreed (n/m) - aliaZ 16:34:06 03/25/05 Too much taper and too much pin offset on the original - Ash's Z 00:11:11 03/26/05 I have the "new" design and still get some slap (n/m) - BOOZTD 3 03:42:34 03/26/05 Same here >> - Greg (Dallas) 10:22:53 03/26/05 Congrats! :) (n/m) - BradZ (FL) 15:28:10 03/25/05 Wiseco pistons - jfvhpilot 19:43:20 03/25/05 Good for you Brian! I can't wait to see her! ;-) (n/m) - MarTTy4653(SeaTTle) 23:02:05 03/25/05
Post a Followup	You cannot reply to this message because you are not logged in.