Subject	urethane (n/m)
Posted by	NytWolf on March 26, 2005 at 12:34 AM
	This message has been viewed 22 times.
In Reply To	Are OEM motor mounts or urethane better? (n/m) posted by ChrisZNA (Sacto, CA) on March 25, 2005 at 10:50 PM
Message
Follow Ups	Need some input... - ChrisZNA (Sacto, CA) 16:43:49 03/25/05 I dont see a EFI harness in there..... - BOOZTD 3 16:45:31 03/25/05 You will probably want to examine your motor mounts too (n/m) - BOOZTD 3 16:53:57 03/25/05 never done the swap but - ZXRider(SoCal) 16:46:20 03/25/05 Rear main seal, EFI harness, engine mounts, water lines - YugoBernie (NoVA) 16:55:11 03/25/05 Are OEM motor mounts or urethane better? (n/m) - ChrisZNA (Sacto, CA) 22:50:30 03/25/05 urethane (n/m) - NytWolf 00:34:17 03/26/05 If you are doing your clutch, you might as well add a - Unluky (MO) 16:56:59 03/25/05 bypass ur egr, easy access with motor out - DragonSi 17:12:50 03/25/05 TT fuel pump and TT fuel pump controller also (n/m) - Zeus 17:17:30 03/25/05 Where/What is a TT fuel pump controller? (n/m) - ChrisZNA (Sacto, CA) 22:46:27 03/25/05 most def do an EFI harness ... and you'll want some - Guapo 17:18:13 03/25/05 EFI Harness...fire hazard if u dont!!!!!! DO IT! (n/m) - Borg79(ON) 17:55:14 03/25/05 while my engine was out i did some stuff in the engine bay - mousersix (San Antonio) 18:45:55 03/25/05 Is there a right up on the water line delete? If EGR and - ChrisZNA (Sacto, CA) 22:48:31 03/25/05 yep, its in FAQ - mousersix (San Antonio) 13:04:30 03/26/05 Replace coolant hose on the back of engine while it's out - doug8867 19:07:57 03/25/05 reference picture inside >> - Zeus 19:49:31 03/25/05 Re: Need some input... - Dlee300z 19:20:59 03/25/05
Post a Followup	You cannot reply to this message because you are not logged in.