Subject	i used the bolts that went to the plenum.
Posted by	Halo Z on March 22, 2005 at 10:54 AM
	This message has been viewed 23 times.
In Reply To	how do i pull an engine that has no upper plenum? posted by mousersix (San Antonio) on March 22, 2005 at 09:10 AM
Message	got some grade 8 washers put the on the plenum bolts, screwed them back in to the lower plenum with the chain, at opp corners, with very little slack and lifted. if it was with the tranny, i wouldn't do that, if its just the motor, it will be fine. i have dont that a few times. ________________________________________________________ RIC, my spelling sux, deal with it. 90 stage stock Sold 93 max hp 207.4 max torque 188.7 *****DEAD***** 93 240sx coup 7 PSI woot! 01 stage 1
Follow Ups	how do i pull an engine that has no upper plenum? - mousersix (San Antonio) 09:10:20 03/22/05 put the plenum back on ... ? (n/m) - Guapo 09:12:22 03/22/05 you can gewt engine slings. (n/m) - nowayout 09:14:45 03/22/05 pointless (n/m) - Guapo 09:18:03 03/22/05 I did it once - Mioduz 09:40:39 03/22/05 Use a tranny bolt hole and A/C bracket hole. - Woody75 (Denver) 10:05:08 03/22/05 i used the bolts that went to the plenum. - Halo Z 10:54:56 03/22/05 You could use the side bracket bolt holes on the heads - KaZ (VaBch) 11:16:09 03/22/05 bolt into the lower plenum (n/m) - PunkZTT(Phoenix) 12:49:02 03/22/05 Call David Blaine. (n/m) - zeorymer 15:27:19 03/22/05 that guy is just a bit odd. (n/m) - Tu 16:14:22 03/22/05 i just kinda made up my own technique as I went along. pics> - scubasteve (Tampa, FL) 16:10:17 03/22/05 Damn, thats a lucky little kid there (n/m) - SaVageZ (Bay Area, CA) 17:46:57 03/22/05 Use the bolt holes where the stock boost solenoids - BOOZTD 3 16:37:15 03/22/05 When I do engine swaps I just lift my engine out.... - TTwinTTurbo 18:34:29 03/22/05 thanks for all your replies :) (n/m) - mousersix (San Antonio) 23:19:21 03/22/05
Post a Followup	You cannot reply to this message because you are not logged in.