Subject	you can gewt engine slings. (n/m)
Posted by	nowayout on March 22, 2005 at 9:14 AM
	This message has been viewed 38 times.
In Reply To	how do i pull an engine that has no upper plenum? posted by mousersix (San Antonio) on March 22, 2005 at 09:10 AM
Message
Follow Ups	how do i pull an engine that has no upper plenum? - mousersix (San Antonio) 09:10:20 03/22/05 put the plenum back on ... ? (n/m) - Guapo 09:12:22 03/22/05 you can gewt engine slings. (n/m) - nowayout 09:14:45 03/22/05 pointless (n/m) - Guapo 09:18:03 03/22/05 I did it once - Mioduz 09:40:39 03/22/05 Use a tranny bolt hole and A/C bracket hole. - Woody75 (Denver) 10:05:08 03/22/05 i used the bolts that went to the plenum. - Halo Z 10:54:56 03/22/05 You could use the side bracket bolt holes on the heads - KaZ (VaBch) 11:16:09 03/22/05 bolt into the lower plenum (n/m) - PunkZTT(Phoenix) 12:49:02 03/22/05 Call David Blaine. (n/m) - zeorymer 15:27:19 03/22/05 that guy is just a bit odd. (n/m) - Tu 16:14:22 03/22/05 i just kinda made up my own technique as I went along. pics> - scubasteve (Tampa, FL) 16:10:17 03/22/05 Damn, thats a lucky little kid there (n/m) - SaVageZ (Bay Area, CA) 17:46:57 03/22/05 Use the bolt holes where the stock boost solenoids - BOOZTD 3 16:37:15 03/22/05 When I do engine swaps I just lift my engine out.... - TTwinTTurbo 18:34:29 03/22/05 thanks for all your replies :) (n/m) - mousersix (San Antonio) 23:19:21 03/22/05
Post a Followup	You cannot reply to this message because you are not logged in.