Subject	The way I see it, one of them is going to break before
Posted by	Ash's Z on March 15, 2005 at 7:46 PM
	This message has been viewed 53 times.
In Reply To	Good idea on doing them different to see what is better posted by atl300zxtt on March 15, 2005 at 07:36 PM
Message	the other. This test is about the best way to determine which is better as it doesn't leave any other variables such as driving style or power output to skew the results. The only differences in the design are with the method of which they were attached. Granted, not every pipe is going to have the same exact weld as the next, but this is as close as you could possibly make your test comparison.. There would be additional testing benefit if this same test were run on several cars at the same time, but I only have one Z. :) I can't see much benefit in making both sets the same and running until one cracks and then follow that by building another set with the other process and drive them until they crack and then try to compare the differences... [ ashspecz.com ] [ agpowers@bellsouth.net ] Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast? If you are out to describe the truth, leave elegance to the tailor. Albert Einstein
Follow Ups	AshsZ-II Ultimate Street Z Progress >>> MANIFOLDS Complete - Ash's Z 19:31:47 03/15/05 Good idea on doing them different to see what is better - atl300zxtt 19:36:11 03/15/05 The way I see it, one of them is going to break before - Ash's Z 19:46:53 03/15/05 I see what you're saying and agree with you - atl300zxtt 20:19:33 03/15/05 saweeeeet....any pricing info yet? - MyZ8u - GT28R Soon - 19:36:53 03/15/05 I highly doubt these will see production anytime soon - BOOZTD 3 19:41:37 03/15/05 I doubt they ever will. Far too delicate of a component to - Ash's Z 19:58:06 03/15/05 My philosophy was gonna be......... - BOOZTD 3 20:09:17 03/15/05 I dunno... - Blu Z 20:33:21 03/15/05 Your doing just fine - ericgl 20:09:58 03/15/05 Good luck (n/m) - BOOZTD 3 19:41:07 03/15/05 Great work. (n/m) - WickedZX (NoVA) 19:44:11 03/15/05 Nice work Ash. Those look very good. (n/m) - Boosted1 19:54:04 03/15/05 look awesome, have to stop bye and check those out (n/m) - CB300ZXTT 19:54:49 03/15/05 Nice work...congrats on completion... - BradZ (FL) 21:05:52 03/15/05 Why do the Greddy manifolds crack so often? - MOTRSPRT--ID 21:26:12 03/15/05 Well, they use 304 SS, which is not a good choice of - Ash's Z 13:39:00 03/16/05 Nice Job! - Carp (Show & Go) 21:43:08 03/15/05 Awesome work! - Owenz 10:50:32 03/16/05 Thanks. I am counting on the heat treating process to - Ash's Z 11:56:46 03/16/05 Ahh, heat treating...props to going all the way in making - Owenz 16:53:31 03/16/05
Post a Followup	You cannot reply to this message because you are not logged in.