Subject	AshsZ-II Ultimate Street Z Progress >>> MANIFOLDS Complete
Posted by	Ash's Z on March 15, 2005 at 7:31 PM
	This message has been viewed 837 times.
Message	The manifold fabrication is complete. Pipes are being shipped off tomorrow for final heat treating. I have chosen to take two different approaches to the construction of these manifolds. One has been constructed with the pipes welded both on the outside as well as the inside and reinforcing tabs have also been used. The second manifold has been constructed with only the inside of the pipes being welded and small tack welds placed on the outside. It is now a race to see who gets there last. Time will tell and we will see. [ ashspecz.com ] [ agpowers@bellsouth.net ] Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast? If you are out to describe the truth, leave elegance to the tailor. Albert Einstein
Follow Ups	AshsZ-II Ultimate Street Z Progress >>> MANIFOLDS Complete - Ash's Z 19:31:47 03/15/05 Good idea on doing them different to see what is better - atl300zxtt 19:36:11 03/15/05 The way I see it, one of them is going to break before - Ash's Z 19:46:53 03/15/05 I see what you're saying and agree with you - atl300zxtt 20:19:33 03/15/05 saweeeeet....any pricing info yet? - MyZ8u - GT28R Soon - 19:36:53 03/15/05 I highly doubt these will see production anytime soon - BOOZTD 3 19:41:37 03/15/05 I doubt they ever will. Far too delicate of a component to - Ash's Z 19:58:06 03/15/05 My philosophy was gonna be......... - BOOZTD 3 20:09:17 03/15/05 I dunno... - Blu Z 20:33:21 03/15/05 Your doing just fine - ericgl 20:09:58 03/15/05 Good luck (n/m) - BOOZTD 3 19:41:07 03/15/05 Great work. (n/m) - WickedZX (NoVA) 19:44:11 03/15/05 Nice work Ash. Those look very good. (n/m) - Boosted1 19:54:04 03/15/05 look awesome, have to stop bye and check those out (n/m) - CB300ZXTT 19:54:49 03/15/05 Nice work...congrats on completion... - BradZ (FL) 21:05:52 03/15/05 Why do the Greddy manifolds crack so often? - MOTRSPRT--ID 21:26:12 03/15/05 Well, they use 304 SS, which is not a good choice of - Ash's Z 13:39:00 03/16/05 Nice Job! - Carp (Show & Go) 21:43:08 03/15/05 Awesome work! - Owenz 10:50:32 03/16/05 Thanks. I am counting on the heat treating process to - Ash's Z 11:56:46 03/16/05 Ahh, heat treating...props to going all the way in making - Owenz 16:53:31 03/16/05
Post a Followup	You cannot reply to this message because you are not logged in.