Subject	I have the spec II - only problem is if you set it to
Posted by	BummedOutMonkey on March 12, 2005 at 2:55 PM
	This message has been viewed 29 times.
In Reply To	questions about the profec b spec II and spec I and type s posted by frozenguy on March 12, 2005 at 02:42 PM
Message	display in PSI you have to turn it on and off when you start the car. Leave it in metric/BAR and it works fine. I like it despite this flaw.
Follow Ups	questions about the profec b spec II and spec I and type s - frozenguy 14:42:02 03/12/05 I have the spec II - only problem is if you set it to - BummedOutMonkey 14:55:46 03/12/05 My NEW spec II "warning" mode problem. (n/m) - PIRANHA 15:10:18 03/12/05 Look at my post above to learn how to set it (n/m) - PLEAZURE in CA (SD) 02:10:58 03/13/05 No need to turn it on and off, just go from low to high - PLEAZURE in CA (SD) 02:10:01 03/13/05 Had spec II and sold it finally. Found a spec I and the - dilly yo 18:25:55 03/12/05 I bought two Profec B spec I from jpandy on Ebay. - SirpriZ 01:00:15 03/13/05
Post a Followup	You cannot reply to this message because you are not logged in.