Subject	Very aggressive, for race fuel only. The chip cannot be
Posted by	Ash's Z on March 02, 2005 at 12:22 PM
	This message has been viewed 594 times.
In Reply To	How good is the MINES ECU for the Z32TT? posted by TheTwinZ (Peru) on March 02, 2005 at 12:16 PM
Message	easily removed because they cover it with a thick epoxy layer which has to be removed before you can desolder the chip. I have a few tricks to getting them out of there, but I wouldn't recommend to buy that ECU unless you plan to use 114octane fuel or better. It pushes some 28 degrees of timing advance on the top end... [ ashspecz.com ] [ agpowers@bellsouth.net ] Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast? If you are out to describe the truth, leave elegance to the tailor. Albert Einstein
Follow Ups	How good is the MINES ECU for the Z32TT? - TheTwinZ (Peru) 12:16:42 03/02/05 Very aggressive, for race fuel only. The chip cannot be - Ash's Z 12:22:12 03/02/05 That is scary (n/m) - atl300zxtt 12:24:05 03/02/05 Damn! Not what I'm looking for...Thanks for the info, Ash! (n/m) - TheTwinZ (Peru) 12:29:05 03/02/05 Zem? - Madhatter10-6 13:42:55 03/02/05 You could take it to 45 degrees maximum with the ZEM, - Ash's Z 13:57:54 03/02/05 Does anyone know what octane this ECU was programmed for? (n/m) - PEwithaZ 14:48:20 03/02/05 Re: How good is the MINES ECU for the Z32TT? - Russell@Z1 12:25:37 03/02/05 $250? wow. (n/m) - TheTwinZ (Peru) 12:32:41 03/02/05 At least hes telling you prices... - Zluster(Project Platypus) 12:39:36 03/02/05 Re: At least hes telling you prices... - CRAZZEPETE. 12:50:28 03/02/05 You missed the point. - Zluster(Project Platypus) 13:42:56 03/02/05 its not necessarily a bad thing if vendors dont want to - mousersix (San Antonio) 14:14:41 03/02/05 This is business my friend - PLEAZURE in CA (SD) 16:35:16 03/02/05 What's wrong with that? He's just letting me know that - TheTwinZ (Peru) 13:01:11 03/02/05 did I say anything about it being wrong? - Zluster(Project Platypus) 13:43:44 03/02/05
Post a Followup	You cannot reply to this message because you are not logged in.