| Message |
removing it? My oil pan has a small dent in it, that I belive is giving me low oil pressure, after hard runs for a few seconds. So as a temporary solution, I have added a half quart of oil extra, and It seems to have worked fine. So I need to remove this dent, but I really don't feel like dropping the subframe, removing the pan, and hammering it out. I went to a shop and asked them to tig weld a bolt on the dent, so we could try to pull it out, but they were scared to do so. So any ideas on how to remove the dent without dropping the pan? Dropping it will be my last resort, thanks for any help.
|
 |
