TwinTurbo.NET: Nissan 300ZX forum - the warping problem was from the bodyshop cooking it
People Seeking Info
 
   


     
Subject the warping problem was from the bodyshop cooking it
     
Posted by maglito on February 15, 2005 at 2:18 PM
  This message has been viewed 196 times.
     
In Reply To You need the lower foam piece and the metal retaininer posted by YugoBernie (NoVA) on February 15, 2005 at 01:57 PM
     
Message and has since been resolved as can be seen here.
for the lazy ones:

For the record I had the foam and the retainer but didn't have the lower spash shield yet at the time so the foam was "lost" (read: blew out) and the retainer I also had but could not figure out where in the heck in install it so I took it back.

DISCLAIMER:
I was REALLY busy in the months of August and September with a cross country move and a house to sell and a fascia to change so admittedly I didn't give as much attention to the Z fascia deal as I would have liked. Had I had some more free time I could have researched the metal retainer clip and waited until I also had lower splash shield before sticking the foam piece in. But, thanks for the tip Bernie.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.