TwinTurbo.NET: Nissan 300ZX forum - Nismo Design Stainless Steel Key
People Seeking Info
 
   


     
Subject Nismo Design Stainless Steel Key
     
Posted by TwinTurboPoweredZ on February 15, 2005 at 5:37 AM
  This message has been viewed 283 times.
     
In Reply To Top ten mods for under $50. posted by ZEngineer (TT) on February 14, 2005 at 09:59 PM
     
Message :I've put together ten things I've done to my car. Each one of them costs under $50 and made my Z considerably more enjoyable.
:Check it out and feel free to add your favorite inexpensive mods to the list. :-)
:1) SilverTwin's short shifter. Once you get used to it, you wonder how you ever lived without it. Some may not like the stubby look though, I personally love it.
:
:2) Moroso water overflow tank. This mod makes too much sense to overlook, especially if you're going with aftermarket SMIC's.
:
:Here are the part numbers from Summit Racing.
:Overflow tank: MOR-63657
:Bracket: 63401
:3) Gauge rings, I got mine from SnowFlake Customs. It's very tasteful-looking in person.
:
:4) McMaster replacement struts. After the hatch slammed shut and nearly shattered the glass while doing work in the trunk area, I knew it was time to buy those. I got the 125 lb struts.
:5) TT sway bar for NA. Just put the two side by side and you'll see how dinky the NA anti-sways are. (thanks again for that Jeff).
:6) Amplified radio antenna. Never have a broken mast again, no motors going up and down every time you turn on the radio. It's just a little black box that uses the antenna input on the radio as a ground and has a +12V wire powering it. Perfect reception. I had my antenna shaved by the body shop.
:7) Hella air horns. Bye Bye queer Z honk.
:8) New battery negative cable. You should all inspect the cable where it meets the firewall. It often cracks at that location.
:9) PTU relocation, AIV & EGR elimination. Makes the engine bay much easier to work on. For the record, I never had any issues after the EGR bypass.
:10).....I ran out of ideas. Anyone care to suggest something?
:George

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.