Subject	I did that as well..
Posted by	kdwest on February 12, 2005 at 1:28 PM
	This message has been viewed 49 times.
In Reply To	Rear Hubs posted by Art111 on February 12, 2005 at 01:25 PM
Message	For my cross drilled/slotted rotors. 1. Clean, brake cleaner works well 2. Sand 3. Clean again 4. Spray and clean with a brake prep solution and/or acetone (NO SMOKING!) 5. Primer, let dry 6. Paint, let dry 7. Put wheels back on... "Boosting as funds and time permits, funds mostly..." There are no stupid questions, but there are a LOT of inquisitive idiots.
Follow Ups	Rear Hubs - Art111 13:25:04 02/12/05 paint them green :-) - Rage (SoCal) 13:27:57 02/12/05 Black Plasti-kote high temp paint bottle says it can - Art111 13:34:49 02/12/05 Oh yeah...I plan to paint the old calipers as well...I'm - Art111 13:36:12 02/12/05 cool deal, good luck. (n/m) - Rage (SoCal) 16:22:26 02/12/05 I did that as well.. - kdwest 13:28:06 02/12/05 I brushed on black rustoleum and they still look great - UpZ (PA) 13:58:53 02/12/05 Re: Rear Hubs - 90300zxtt 14:51:55 02/12/05 It would be easier if you use a Wire Wheel on a drill - shawn300zTT GT28R soon 14:55:06 02/12/05 You may know this already... - AztecTT (Azure Motoring) 15:02:09 02/12/05 I cleaned with acetone, taped off rotor surface, primed and - zzman (nashville) 15:21:24 02/12/05 Damn nice car...you going to go to the - sumva_z 15:46:02 02/12/05 Thanks John. Yeah I'll def. be going. The registration link - zzman (nashville) 15:54:22 02/12/05
Post a Followup	You cannot reply to this message because you are not logged in.