Subject	Could be the main bearings, I believe they have a
Posted by	twinturbineZ on February 01, 2005 at 2:40 AM
	This message has been viewed 30 times.
In Reply To	Funny, but those pieces look like heads to screws. posted by dilly yo on February 01, 2005 at 01:18 AM
Message	layer of bronze in them?
Follow Ups	Maybe you can help me out here... Interesting... - ZFreak (Dallas) 00:42:30 02/01/05 Dem thar look lak gold nuggets to meh (n/m) - ENVYMYZ 01:13:41 02/01/05 Bernie suggested that it's a bolt - ZFreak (Dallas) 01:21:00 02/01/05 But they would be magnetic if that were the case. - Marshall 17:17:02 02/01/05 Funny, but those pieces look like heads to screws. - dilly yo 01:18:31 02/01/05 hmm.. point taken. Thanks. (n/m) - ZFreak (Dallas) 01:22:03 02/01/05 Could be the main bearings, I believe they have a - twinturbineZ 02:40:22 02/01/05 all these suggestions are under the assumption that these - frozenguy 02:49:34 02/01/05 You don't see the + pattern for a Phillips screwdriver? - SeedyROM 03:03:26 02/01/05 Looking a bit closer shows evidence on nearly all pieces (n/m) - SeedyROM 03:05:12 02/01/05 it just doesn't make sense to me.. i dunno.. - frozenguy 03:34:25 02/01/05 Where inside the engine would you find a phillips - twinturbineZ 03:38:17 02/01/05 Ideally you wouldn't...not that I know of - SeedyROM 05:12:11 02/01/05 Oil pump backing plate................. (n/m) - Kyle(Houston) 09:22:52 02/01/05 Ah, did not know that. Thanks :) (n/m) - SeedyROM 13:55:41 02/01/05 Re: Maybe you can help me out here... Interesting... - Dokebi 03:13:25 02/01/05 Sabotage, sabotage I tell you. - Spddracer 06:31:35 02/01/05 raisinettes (n/m) - Chris(NJ) 08:52:14 02/01/05 I'm thinking more like coffee beans (n/m) - TeddyJ 09:41:56 02/01/05 Re: never seem a piece that looks like that when i rebuilt - nowayout 10:25:00 02/01/05 look like main bearing pieces - mossyoak 11:10:23 02/01/05 He ran over somebody with fillings in his teeth? (n/m) - ZXtaZTT 12:17:18 02/01/05 Do you have any more pics? - Marshall 17:24:08 02/01/05
Post a Followup	You cannot reply to this message because you are not logged in.