Subject	IMMENSELY helpful
Posted by	Zrevolver on January 23, 2005 at 11:19 AM
	This message has been viewed 59 times.
In Reply To	Use this: posted by YugoBernie (NoVA) on January 23, 2005 at 10:48 AM
Message	thanks big time, wish I had posted before I started, should save us a ton of time on the diff, already got the subframers in. One ques: Energy suspension instructions were very clear about leaving those "cup-like" outer shells in the subframe to support their bushings. this makes it impossible to press the middle shell out though. Did we got throught he asspain of pressing the middle shells out while leaving the outers inplace for nothing? Is ES wrong? The subframers slipped right into place with a little grease and the outer shells still in place. Thanks again for that post, enormous help
Follow Ups	Anyone got before-and-after pics of rear diff bushings - Zrevolver 10:46:40 01/23/05 Use this: - YugoBernie (NoVA) 10:48:41 01/23/05 Bernie those look like Delrin sub-frame bushings - SkiFly01 10:55:58 01/23/05 The Derlins are stiffer but I didn't do that install/car so - YugoBernie (NoVA) 11:00:45 01/23/05 yes, they are Delrin. i've never been in a subframe spacer - Bernie (OOParts International) 14:53:09 01/23/05 agreed ... and therefore might as well do solid alum - Guapo 14:55:26 01/23/05 yeah... if i were to do it again, i'd go with 300degrees' - Bernie (OOParts International) 21:29:57 01/23/05 IMMENSELY helpful - Zrevolver 11:19:44 01/23/05 I didn't do that write up, I would assume the ES instruction - YugoBernie (NoVA) 11:55:51 01/23/05 if ES was writing instructions for changing tires it would - Zrevolver 21:43:14 01/23/05 I think they come out... - Z'Guy 14:27:05 01/23/05 subframe bushings, not diffy (n/m) - Guapo 14:40:54 01/23/05 Oops! Still another good write up! (n/m) - Z'Guy 14:43:02 01/23/05 that's correct, for ES bushings, the outer shell stays in... - Bernie (OOParts International) 14:50:45 01/23/05 All pics from my subframe bushing TECH writeup are here... - Bernie (OOParts International) 14:48:53 01/23/05 subframe and rear diff bushings are conquered - Zrevolver 22:32:25 01/23/05
Post a Followup	You cannot reply to this message because you are not logged in.