Subject	How are you supposed to tighten down the bolts with the car
Posted by	Haasz32 on January 19, 2005 at 7:16 PM
	This message has been viewed 51 times.
In Reply To	Thought on the ES bushings. posted by Spddracer on January 19, 2005 at 06:46 PM
Message	on the ground? The z sits so low that I know I can't slide underneath there very far, and I'm pretty slender. I guess the only way around that is to have the car on ramps. But, would you need to jack up the rear of the car to even the car out if you put the front on ramps? I just installed ES tension rod bushings myself this past fall. I haven't driven the car much since then. But, I have noticed a popping (I can hear and feel it) when I run over a bump like the 1 inch height difference when pulling into my garage. This might be caused by the front ES anti-sway bar bushings I installed at the same time... I'm not totally sure. I think I may have the wrong size up front. I had a hard time measuring the diameter with the tools I had at the time. I'm going to take a look at that this winter, while the car is down in the garage.
Follow Ups	ES Bushings: What's the verdict? - just4kinks 17:21:00 01/19/05 T-rod bushings have been found to cause problems. - jkperformance 17:25:38 01/19/05 ES tension rods bushings are the ones - TARGETZ 17:27:11 01/19/05 the only "problems" are ES bushing use in tension rods... - BradZ (FL) 17:28:06 01/19/05 Re: ES Bushings: What's the verdict? - Guapo 18:08:33 01/19/05 But I like this part the best... - Woody75 (Denver) 23:19:17 01/19/05 Thought on the ES bushings. - Spddracer 18:46:42 01/19/05 How are you supposed to tighten down the bolts with the car - Haasz32 19:16:52 01/19/05 The easiestway is a drive on rack. But ramps would work. (n/m) - Spddracer 19:24:31 01/19/05 how do you figure? - fourZero 19:33:06 01/19/05 Spddracer, is right about the preload thing. - Spongerider :) 19:40:44 01/19/05 point taken, but I don't want to guinea pig this theory - fourZero 19:49:28 01/19/05 I would not use ES either. (n/m) - Spongerider :) 19:55:38 01/19/05 Me either. I put Nizmos in mine. I hate urethane anything - Spddracer 20:10:21 01/19/05 right, but urethane is free in the control arm, not fixed - z32ttvert 22:03:05 01/19/05 Re: right, but urethane is free in the control arm, not fixed - kuah@splparts.com 07:50:40 01/20/05 Thanks for the replies everybody. - just4kinks 07:58:42 01/20/05
Post a Followup	You cannot reply to this message because you are not logged in.