Subject	I wouldn't think so. It will bolt to the floor board with
Posted by	Milo (Sport Z Magazine) on January 11, 2005 at 12:42 PM
	This message has been viewed 21 times.
In Reply To	Re: Hmm...good question. posted by changv on January 11, 2005 at 11:39 AM
Message	little issue probably, but I think the major hangup would be with the mounting points to the rear fender well. Normally for a regular coupe you just cut two simple panels and you can install the cage around the interior. With the conv I believe you have some huge obtrusive black plastic panel. I imagine you could MAKE it fit going "full monkey" on it. But it would require a lot more fabbing than normal. Besides, I am not sure the rollcage will give any issues to the existing bar that is already in there.
Follow Ups	roll bar - changv 10:30:28 01/11/05 email milo or Joel (pa) (n/m) - JDMz32smity 10:32:35 01/11/05 Hmm...good question. (n/m) - Milo (Sport Z Magazine) 11:04:39 01/11/05 Re: Hmm...good question. - changv 11:39:43 01/11/05 No. (n/m) - YugoBernie (NoVA) 12:33:01 01/11/05 I wouldn't think so. It will bolt to the floor board with - Milo (Sport Z Magazine) 12:42:26 01/11/05
Post a Followup	You cannot reply to this message because you are not logged in.