Subject	This is DaisyView - I will be using Labview tho. >>>
Posted by	Ash's Z (Florida) on August 13, 2000 at 2:08 PM
	This message has been viewed 23 times.
In Reply To	damn... what software is that? and how does it connect? (n/m) posted by Logik (Pittsburgh) on August 13, 2000 at 01:59 PM
Message	The interface isnt simple tho. I'm sure you know I already have a P550 computer in my Z, you need a data acquisition board and it is interfacing directly with the sensor lines coming into the ECU. My CarPuter Headquarters: http://ashleypowers.homepage.com agpowers@bellsouth.net
Follow Ups	NA+TT Conversion. DAQ Installed - PICS INSIDE!!! - Ash's Z (Florida) 13:34:09 08/13/00 are u going to be able to play your MP3 > - HALO Z(MiddleGA) 13:43:07 08/13/00 say ash would you happen to have a write up on the - chris (houston) 13:45:19 08/13/00 There is no "writeup" that I know of other than on my site.> - Ash's Z (Florida) 13:52:34 08/13/00 Yes. Details inside. - Ash's Z (Florida) 13:49:22 08/13/00 are you even going to use a tt ECU, or will computer take > - Xi0nX4 (ohio) 19:16:34 08/13/00 If that's WOT, then you your TPS needs adjusting. - SeedyRom 13:57:15 08/13/00 True true, but remember, this was at 2:00AM last night; :-D (n/m) - Ash's Z (Florida) 14:06:31 08/13/00 damn... what software is that? and how does it connect? (n/m) - Logik (Pittsburgh) 13:59:20 08/13/00 This is DaisyView - I will be using Labview tho. >>> - Ash's Z (Florida) 14:08:16 08/13/00 HOLY SHIT...that is BADASS - SteAmyZ (T-Top Bag Man) 14:26:41 08/13/00 Very cool! (n/m) - Arnel [njoynmyz.com] 15:25:05 08/13/00 You are now officially "OUT OF CONTROL" LOL - Z CRAZY 15:27:08 08/13/00 What DAQ module did you use? (n/m) - MIT-Z 15:57:55 08/13/00 its on his site BTW (n/m) - SteAmyZ (T-Top Bag Man) 16:03:48 08/13/00 Re: Can you monitor all at once>>> - scoTT [San Diego] 16:53:17 08/13/00 Yes. Any sensor you wish, as many as card supports>> - Ash's Z (Florida) 18:33:39 08/13/00 your O2 sensors aren't hooked up right. they should be >0.8 - Bernie 19:36:02 08/13/00
Post a Followup	You cannot reply to this message because you are not logged in.