My TTZ sit on Eibach 0.8" drop, stock wheel/tire size and stock facia.
The mid size Craftsman and HF aluminum's rear jack frame doesn't clear the center buttom facia by 20mm.The jack doesn't clear the center buttom facia by 20mm and the facia is almost perfectly flat unlike other's beat up and sagged in the center buttom.
The rear jack frame doesn't clear the side sill neither for the saddle to reach under the front frame.
I always drive the front tires on a 35mm thick wood board each side for more clearance.1.5 ton Craftsman jack's height is 6.25"
and the Harbor Freight 3000lbs jack is 6.1" (mid size)
The difference is 3.66mm, and HF still doesn't clear the facia.
The small HF is surprising sitting 8" tall for $80 according to the spec, shrug..... dunno, it doesn't look that tall although I didn't put them side by side for close comparism.
In conclusion, the saddle of the jack clears any part of the Z32 but the Z32 is simply too low for any mass production aluminum floor jacks available in the market.
===========================================
:The mid size aluminum jack won't clear the slash guard (and/or the facia) to reach below the crossmember with an 0.8" drop. :You will still have to drive the front wheel on the wood boards to clear.
:The small US General might clear, but I have not yet tried it. ( <-- it won't clear according to its 8" tall frame spec)
Erick
 |
