Subject	if I had it to do over again, I'd go w/ 530BBs because of
Posted by	boileralum on December 22, 2004 at 3:24 PM
	This message has been viewed 70 times.
In Reply To	kinda off topic, but noticed you have the GT28R turbo's posted by JokerF15 (NyxMotorsports) on December 22, 2004 at 03:21 PM
Message	the PITA these were to install at the time. HakenTT's writeup was pretty good (a little misleading as to the cost factor, but otherwise OK), but reading it makes the process seem a lot easier than it was - especially since htat was the first time I had pulled a motor, etc. I do like the performance of the turbos, but I would've preferred less headaches. Rule #1 - There's always a bastard! JRH(KY): for some reason, when I hear the word 'tranny' I think of transvestite before I do transmission. don't ask me why boileralum: FAGMO! ----------------------------------------- Bill (ImTheDevil): blah blah blah me: Just because you are covered in gasoline right now, doesn't mean you are right! ----------------------------------------- JRH (KY): I'm also using up a weekend this month for Indy and a weekend next month for the USGP. Throw in our trip to PA and GF is getting tired of my car habit. Boy I'm going to miss her :-D
Follow Ups	Where can I find 5-bolt DP gaskets... - The_S_Man (Phoenix) 15:10:17 12/22/04 Specialty Z should be able to get them. JWT has a p/n - boileralum 15:14:07 12/22/04 kinda off topic, but noticed you have the GT28R turbo's - JokerF15 (NyxMotorsports) 15:21:13 12/22/04 if I had it to do over again, I'd go w/ 530BBs because of - boileralum 15:24:21 12/22/04 How responsive are the turbo's? Compared to stock units? - JokerF15 (NyxMotorsports) 18:07:58 12/22/04 I am installing GT28R turbos right now.... - The_S_Man (Phoenix) 15:59:57 12/22/04 I'd be intersted in the templete for the Actuators. - JokerF15 (NyxMotorsports) 18:06:33 12/22/04 I might have a spare set to sell you. Email me. (n/m) - AzHeat 15:15:45 12/22/04 SPLparts (n/m) - aliaZ 15:31:27 12/22/04 We keep them in stock also (n/m) - Russell@Z1 15:36:38 12/22/04 Any vendor here - College Boy 16:06:36 12/22/04 I run custom made copper gaskets which are .060" thick. (n/m) - AzHeat 16:09:07 12/22/04 you plan on selling those ever or just for urself? - College Boy 16:13:02 12/22/04 I only had one set made. Had it made on a CNC machine from - AzHeat 16:25:34 12/22/04 Mine is thicker ;) (n/m) - kuah@splparts.com 23:03:46 12/22/04 Actually... the Garrett Distributor I bought the turbos... - The_S_Man (Phoenix) 16:14:31 12/22/04 Any Nissan dealership should be able to get them. - Dallas DamonZ 16:18:37 12/22/04
Post a Followup	You cannot reply to this message because you are not logged in.