TwinTurbo.NET: Nissan 300ZX forum - Re: nice, lets see how long it lasts.....
People Seeking Info
 
   


     
Subject Re: nice, lets see how long it lasts.....
     
Posted by Russell@Z1 on December 01, 2004 at 9:04 AM
  This message has been viewed 72 times.
     
In Reply To nice, lets see how long it lasts..... posted by Halo Z on December 01, 2004 at 05:43 AM
     
Message The time to run all the wiring for, wire in, mount, supply and run all the vacuum lines and T-s for, then properly configure and AVC-R is serveral hours plus materials.
I don't think that price is unreasonable. Once again compare to the other known and respected shops, and get back with me. We try to keep our prices below the average.

On the driveshaft. The Auto NA and TT NA front yokes are completely different. The TT auto has the same output shaft as a 5sp. The NA auto has a smaller one. The second difference is the length of the shaft. The shaft for his car is also a differnt length than any regular Z32. The TT AUTO transmission is longer than the NA auto trans. Combined with the fact that he is using a NA diff which the input flange is a different shape and at a differnt position that the TT diff. We end up with the need for a special shaft that we offer.
It fits Auto TT's that have done a NA rear diff swap and 2seater NA's that have a TT auto trans.

Russell Floyd

Z1 Motorsports
www.z1motorsports.com
1990+ Nissan Z specialists

Used Parts, New parts, Service/Repair and Performance

1200 Carrollton Hwy
Temple, Ga 30179

770-562-8668
770-562-8664 (fax)

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.