Subject	Re: You have any other supporting mods, that is dang good
Posted by	NitroPow on November 24, 2004 at 12:58 PM
	This message has been viewed 50 times.
In Reply To	You have any other supporting mods, that is dang good posted by AzHeat on November 24, 2004 at 12:48 PM
Message	Basically 3" cat back exhaust and the dual intake. Also ACT racing clutch and ACT Flywheel. But for the engine we havent done anything else than the mods i already mentioned. Absolutely nothing else. We just replace the gaskets with 1.2mm and close the engine. Thats it. Also our timing was set at 17" all the time Speed is a passion that can lead to madness.
Follow Ups	Just came from the dyno. 525rwhp and 442.1tq - NitroPow 12:22:05 11/24/04 isn't the tq a little low? Otherwise LOOKS GOOD. (n/m) - spotz 12:24:07 11/24/04 I think it is a little. But like i said we just raise the - NitroPow 12:30:44 11/24/04 It is little not much, he is only running 19 psi. (n/m) - AzHeat 12:47:31 11/24/04 It apparently has dual intake too. Tuning should give you - Scotts94z32 12:47:10 11/24/04 We had an electronic A/F but we couldnt get the readings - NitroPow 12:54:07 11/24/04 Just trying to figure out my nProbe... what does the 90%DC - Scotts94z32 13:42:31 11/24/04 Means his injectors are in the red zone for cycle time. - Dallas DamonZ 14:11:09 11/24/04 You have any other supporting mods, that is dang good - AzHeat 12:48:28 11/24/04 Re: You have any other supporting mods, that is dang good - NitroPow 12:58:46 11/24/04 Re: Just came from the dyno. 525rwhp and 442.1tq - eriksu9 14:28:40 11/24/04 What is the stock head gasket width? - silverZman 14:50:00 11/24/04 awesome numbers - can't wait to dyno myself! (n/m) - tip 15:08:28 11/24/04 I just dynoed mine as well......517RWHP / 534 RWTQ - ScreemZ 17:11:54 11/24/04
Post a Followup	You cannot reply to this message because you are not logged in.