Subject	Put it this way bro, he says the t-belt snapped right? it al
Posted by	Eishozzz on October 31, 2004 at 4:35 AM
	This message has been viewed 48 times.
In Reply To	well, in that case posted by SaVageZ™ on October 31, 2004 at 01:06 AM
Message	l depends at what rpm the t-belt snapped. Lets say if it snaped at idle 700-850rpm, you should expect a few bent valves, valves,machining,gaskets will cost you close to 600-900 depending on the machine shop. BUT, lets say if the t-belt snapped at high rpm's then there is a chance that the motor might have a cracked or even a broken pistone if thats the case, you will waste 500 bucks. You can buy a good jdm motor from arley TIS_Z_LIFE For about $1600-1700 which will come with a 6month warrenty, Good luck. Eis
Follow Ups	What should a VG30DETT USDM fetch lately? - ZFreak (Omaha) 00:06:29 10/31/04 umm timing belt snap=bad - ix3 00:49:09 10/31/04 not on a TT... - SaVageZ™ 00:55:17 10/31/04 Either way, $500 is too much? - ZFreak (Omaha) 00:59:03 10/31/04 I'd pay 500 - SaVageZ™ 01:00:58 10/31/04 Need to clarify... it's ONLY the engine..not the car. (n/m) - ZFreak (Omaha) 01:04:51 10/31/04 well, in that case - SaVageZ™ 01:06:21 10/31/04 Put it this way bro, he says the t-belt snapped right? it al - Eishozzz 04:35:38 10/31/04 you missed his point - Marshall 07:28:24 10/31/04 SaVageZ and you are both wrong. Broken t-belt = bent valves - not-hrz 08:14:36 10/31/04 OK . Thanks. (n/m) - ZFreak (Omaha) 11:38:01 10/31/04 Reading comprehension - Marshall 13:59:35 10/31/04 the heads don't hit the block, the valves hit the pistons... - xZeler8 13:13:01 10/31/04
Post a Followup	You cannot reply to this message because you are not logged in.